Brakes wear down. That is what they are for. The job of this guide is to help you notice when wear has become a safety problem, and to give you a short list of questions so a garage quote is something you can compare. It is not a diagnosis of your car. If the pedal feels wrong, treat it as unsafe until someone has checked it.

Signs the pads or discs are wearing out

  • A squeal or squeak when you brake. Many pads have a small metal tab that squeals on purpose when the friction material is getting low. Damp weather and dust can squeak too, especially on a cold start, and then go quiet. If the noise stays, or it is there every time you slow down, have it checked.
  • A grind or a metal scrape. That often means the pad material has gone and metal is meeting the disc. Every mile makes the repair bigger and the braking worse. Stop using the car if you can, and have it recovered if the only route is a busy road.
  • A judder through the pedal or the steering wheel as you slow down. Often worse from speed, such as coming off the M8. Uneven discs are a common cause. It can also be a related part, so ask the garage what they found rather than ordering discs because a forum said so.
  • The car pulls to one side when you brake. A sticking caliper or uneven wear can do this. It is a reason to book the car in promptly and to drive gently until then, if it still stops in a straight-enough line. If it pulls hard, do not carry on.
  • You need more pedal, or the pedal feels soft or sinks. That is different from worn pads. It can be air in the system or a fluid leak. Do not drive it. Have it recovered. Low brake fluid is a warning, not a top-up-and-go. The brake warning light section of our warning-lights guide says the same: if the handbrake is fully off and the light stays on, do not drive.
  • It takes longer to stop than it used to. Trust that feeling. Have the brakes measured.
  • An MOT advisory. Pads close to the limit, discs worn or corroded, imbalance, or brake pipes starting to corrode. Salt on gritted Glasgow roads is hard on pipes and the back of discs. An advisory this year is often a fail the next. The free MOT history check shows what was written down.

A pothole can knock steering and suspension, and it can also show up as a vibration you first notice under braking. If you have just hit one, use what to check after a pothole as well as this page.

Pads, discs, or both

Pads are the friction material that grips the disc. They are the part that wears first. Discs wear more slowly, and they can also corrode, score or wear unevenly.

A garage may recommend:

  • Pads only, if the discs are still thick enough and smooth enough for that car.
  • Pads and discs together, if the discs are under the minimum thickness, badly scored, or so uneven that new pads would bed in poorly.
  • A caliper or a hose as well, if something is sticking or leaking. That is a bigger job. Ask why.

Both sides of an axle are normally done together. The front and the rear wear at different rates. Ask which axle they mean, and ask them to measure the other one so you are not back in a month.

New pads and discs are the sensible default. Brakes are a poor place to save money with an unknown used part. A used caliper can be reasonable if it is described honestly and it is the right one. Used friction material is not a bargain.

What to ask before you agree

Get this in writing, even if it is a short email.

  • How much material is left on the pads, on each side, and the disc thickness against the minimum for this car.
  • Which axle, and whether the other axle is fine or just "not failed yet".
  • Exactly what the price includes: parts, labour, and a road test afterwards.
  • Whether they need to bleed the brakes, and if that is in the price.
  • The brand or the specification of the parts. "Standard quality" should still be the right part for the car. Take the registration so they look it up.
  • Whether the car is safe to drive to them. If they say no, arrange recovery. Do not hope.

Prices vary with the car. A small hatchback and a heavy 7-seater are different jobs, and a rusty caliper bolt can add time. For a big quote, get a second one that lists the same work. Repair garages around Glasgow are listed from DVSA and OpenStreetMap data. They are not partners and they are not rated here.

If you want to compare parts yourself, read finding car parts in Glasgow and then let the garage fit them. Brakes need to be fitted and checked by someone who will stand over the work. Buying a box of pads does not finish the job.

After they are fitted

New brakes can feel different for the first few careful stops while the pads bed in. Ask the garage what they want you to do for those miles. Avoid a hard stop from speed on the way out of the car park if they have told you to bed them gently.

If the car pulls, the pedal goes soft, or a grind comes back, return to the garage that did the work before you drive it properly. A warning light that stays on needs the same call. Do not top up brake fluid to hide a leak.

On a car you are viewing, a test drive should stop in a straight line. The viewing checklist includes that. At the lower end of the market, price the work before you decide the car is cheap. What £5,000 buys is the longer version.

An ABS light is not, by itself, a pad job. It needs a code read. If the car will not stop properly, get it off the road when you can and call your breakdown cover. We are not a recovery company.

Common questions

Is a squeak always worn pads?

No. Moisture and surface dust squeak, then go quiet once the brakes have warmed up. A squeak that is there on every stop, or a tab that has started to sing, needs a look. A grind is more urgent than a squeak.

Can I see the pads myself?

On some cars you can see the outer pad through the wheel. A glance tells you very little about the inner pad, the disc thickness or a sticking caliper. A measurement is the useful check. If you cannot see them, do not remove the wheel at the roadside.

Will worn brakes fail the MOT?

They can. The test checks performance, balance, the condition of pads and discs, pipes and hoses. An advisory means it passed with a warning. A fail means it is below the limit. Look at the fail sheet, or the MOT history, and see what to do if the MOT failed.

Should I replace discs every time I replace pads?

Only if the discs are worn, scored or uneven enough to need it. A garage should be able to say which, with a measurement. Replacing good discs "while we're there" is a choice, not a rule. Ask for the price with and without them.

Is it safe to drive to the garage?

If the pedal is firm, the car stops straight, and the noise is a squeal rather than a grind, many people drive gently to a booking. If it grinds, pulls hard, the pedal sinks, or a brake warning light stays on, do not drive it. Recover it.

Where we can help

Use the car problem helper to match what you feel to the next step, or tell us the symptom and we will help you think about what to ask a garage. Asking is free. The garage you choose gives you the price, and you decide.